![]() ![]() But once it's up, the WPN111 seems to stay connected fine with good range.ģ. Now each time the PC is rebooted, the same procedure has to be repeated to manually connect. Selected VirtualProfile, input the SSID, and "connect anyway" which prompted another "invalid filename" and "failed to connect" messages but it connected. Had to click on the PC icon and went into ConnectToANetwork, where my network showed up both as VirtualProfile(secured) and as UnnamedProfile(unsecured). When clicking on the icon, "invalid filename" flashed twice before the SmartWizard would open. The Netgear SmartWizard first showed up minimized with the green radio icon on the taskbar, then just the red icon on the corner toolbar. When the PC was rebooted, the WPN111 didn't automatically connect. This caused some confusion and created two copies of my network in the scan (more on that below).Ģ. ![]() The WEP/WPA encription had to be configured after the SmartWizard is installed. The install screen only allowed unsecured installation. It worked the first time but not without bugs.ġ. Ran the Netgear Setup Wizard and followed instructions to let it install the h/w. Just installed a new WPN111 2.0 in Vista. The internal card works great at most open sites. The WPN111 sticks like glue to my router under all conditions, distance and speed. However, some internal cards, and the Dell 1505n card, in particular, do not make stable connections with some routers (WPN824 in my case). I also think that Netgear designed the drivers for Vista computers that did not come with internal cards, figuring that they would not be used anymore. But, once installed, the Netgear drivers are in like Flint and Vista seems to get along with them just fine. I have a strong hunch that as long as Vista had access to an internal card through its drivers, then it refused to properly load drivers for the WPN111. Of course IE only uses one connection and prefers the internal card. Finally and get this: reinserted the WPN111, and both adapters connected with different local addresses. It worked right away and connected locallly and to the Internet. Then reinstalled drivers for my internal card. After this I pulled the WPN111 out of the USB slot. The Netgear utility worked right away and has continued to do so, as long as the Netgear card is in the USB slot. Worked like a charm ! Followed directions on the Wizard and the blue light started flashing and Vista recognized the adapter and created a connection to the router and the Internet. Installed the WPN 111 drivers along with the utility. Then with the device manager, uninstalled the internal card and removed the drivers. I downloaded latest drivers from Dell for my internal card (Broadcom) and the v2.0 drivers from Netgear. Made sure I had deleted all Netgear drivers and utilities first. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |